Light
Loading this strip…
NightplotNo Lights to turn off yet
No Lights to turn off yet
Nightplot0 Lights on · 1 not answering
Lights / WLED
Hostname: 10.0.1.29
Not answering. Beads stay grey — the last colour is not shown.
What’s wired to the controller. Apply writes it, then reads it back.
Reading /json/cfg bus…
Only the fields Nightplot understands on this firmware.
Reading /json/cfg…
Current readings from this Light; no controller changes.
Current health unavailable. Last seen 11/1/2026, 9:56:29 AM.
Explore Segment colours against WLED’s Safe current limit; no controller write.
Planning estimate only: saved Segment colours start this scenario; unset colours start at full RGB with zero white. You can change them here without saving or writing WLED. These are not measured amps.
No saved Segments to estimate.
Saved Segments at chosen colours: ≈ 0 mA
Reading Safe current limit… No comparison available.
60 LEDs are outside saved Segments and are not included.
Model: up to 20 mA per RGB channel per LED, plus up to 20 mA for RGBW white, scaled by selected brightness. Effects, real LED variation, controller overhead, voltage drop and wiring are not measured. Do not use this as a fuse or supply rating.
The address Nightplot uses to reach this Light. Changing it does not rename the controller.
Segments unknown
Nightplot forgets it. The controller isn’t changed.
Unknown impact is not safe. There is no “I understand” override.
0 Lights on · 1 not answering